| | | |
| Description: |
The IC-485S and IC-485SN represent hardware solutions to the problem of converting signals between two standards. Data transfer can take place at up to 1200m (4000'), over four or two wire cable for full or half duplex, respectively. The converters can handle any RS-485/RS-422 device allowing it to function as a short haul modem or interface converter. Request to send (RTS) selection allows up to 32 receivers to be set up in a multidrop installation, making for a cost effective network configuration.
|
| Specifications: |
| Product Description: |
ATEN serial adapter |
| Device Type: |
Serial adapter |
| Form Factor: |
External |
| Interface (Bus) Type: |
Serial RS-232 |
| Dimensions (WxDxH): |
2.1 in x 2.9 in x 0.7 in |
| Weight: |
2.1 oz |
| Cabling Type: |
Serial |
| Data Link Protocol: |
Serial |
| Data Transfer Rate: |
100 Kbps |
| Technical Information: |
| Number of Connectors |
3 |
| Connector Details |
1 x 25-pin DB-25 Female RS-232
1 x 4-pin Terminal Block (Screw)
1 x RJ-11 |
| Data Transfer Rate |
100Kbps |
| Material |
Plastic |
| Power Description: |
| Input Voltage |
9 V DC |
| Power Consumption |
90mW Maximum |
| Physical Characteristics: |
| Shipping Dimensions |
2.5" Height x 6.5" Width x 9.5" Depth |
| Weight |
2.12 oz |
| Shipping Weight |
0.41 lb |
| Miscellaneous: |
| Additional Information |
Data transmission controlled by the RTS signal
DCE or DTE selectable switch
Point to point, multidrop, and simplex/duplex link selection
Four wire full duplex & two wire half duplex
Non powered operation
Bi-directional |
| Compatibility |
- |
| | |
|
| |
